top of page

How it Works 

How do you inflate the shirt?

Before inflating your HERO make sure the correct size CO2 cartridge is installed. The shirt is inflated by pulling down sharply on the toggle. If your shirt has been inflated make sure you replace the cartridge so it is ready for use next time.

​

Can I wear my HERO shirt inflated?

HERO shirts can be worn as a normal rash guard or inflated.  

​

Can I orally inflate the shirt and auto inflate as well?

You should never inflate your HERO by the oral inflation tube and activate inflation via the CO2 cartridge at the same time. This could severely damage the inflation chamber and cause it to fail. 

 

Can I inflate the HERO shirt and add more air through the oral tube?

If you have activated the inflation of your HERO shirt via the CO2 cartridge and feel it needs more air you can blow into the oral inflation tube to “top up” the inflation chamber if required. 

​

Can I partially inflate my HERO Rash Guard?

HERO Rash Guards can be partially inflated. This can be very useful when learning to swim, snorkeling, surfing, water skiing etc. If your Hero is partially inflated you should not activate the CO2 cartridge at the same time as the extra volume in the inflation chamber could damage the chamber.

​

What if it doesn’t inflate when I pull the cord?

If the shirt does not inflate you can inflate it by blowing into the oral inflation tube located in the opening on the right side of the shirt near your shoulder. You should also check to see that the cord is not tangled and is moving freely. If the shirt still fails to inflate you should not wear it until the problem has been identified and resolved.

​

 

3 way inflation.jpg

(components above are used in ISO certified models)
How to use the HERO  

Is my HERO shirt a lifejacket?

Your HERO Laguna model is COAST GUARD CERTIFIED as a lifejacket. The HERO Bondi model is certified by ISO as a buoyancy device. Check with your local authorities if you are unsure if it complies with your intended use.

​

Can I use my HERO shirt as a cushion or pillow?

You should never sit on your HERO shirt or use it as a pillow either inflated or deflated. Sitting on your HERO shirt could severely damage it and cause it to fail. 

 

Can I wear my HERO shirt inflated?

HERO shirts can be worn as a normal rash guard or inflated.  

​

Can I wear my HERO shirt under clothing?

Wearing your HERO shirt under clothing or a wetsuit may affect its performance and hinder its activation. Your HERO shirt can be worn over a tee shirt or wetsuit so long as it does not hinder activation.

​

Can I wear my HERO shirt on a boat?

You should always check with your local authorities to find out what standard of protection is required when participating in any water-based activities.  The Laguna model swim shirt is certified as a CG certified lifejacket.

​

Can I use my HERO Rash Guard in a pool?

HERO rash guards can be used in salt water, fresh water or in swimming pools. After each use your HERO Rash Guard should be rinsed well as per our cleaning instructions.

​

Can my child wear the HERO Rash Guard?

HERO Rash Guards are available from a child’s size 4 to an adults size XXL. Wearing a HERO Rash Guard does not remove your responsibility as an adult to supervise your child at all times especially when around water.  The Laguna model (CG Certified) is only available in adult sizes. 

​

How do I deflate my HERO shirt?

To deflate your Hero shirt locate the cap that is on the top of the oral inflation tube. Turn the cap over and push the raised section of the cap into the top of the tube. When this is being done you should be able to hear the CO2 escaping from the inflation chamber. While pressing the cap down on the oral tube gently press against your shirt to help expel all of the CO2. Make sure that your inflation chamber is completely deflated before activating your CO2 cartridge again.

Sizing & Cleaning  

SOS2.JPG

How often should I clean my HERO Shirt?

HERO shirts should be rinsed in fresh clean water after each use and placed on a plastic coat hanger to dry out of direct sunlight. It is recommended that special attention is paid to the UML inflator. Threads should be rinsed well removing any salt, sand or silt around the activator. 

 

Can I wash the HERO shirt?

Your HERO shirt can be hand washed in cold water with a gentle soap. Remove the inflation chamber prior to washing. Dry in a shaded location on a plastic coat hanger out of direct sunlight.

 

  • Do not use bleach or strong detergents.

  • Do not tumble dry.

  • Do not iron.   

​

 

Cartridge Replacement 

How many times can I use the shirt before replacing the CO2 cartridge? 

Cartridges are not reusable, once used they should be replaced with a HERO certified CO2 cartridge and safety clip before the shirt is worn again. The CO2 cartridge should be replaced after activation or at least every 12 months. CO2 cartridges have a shelf life and must be replaced at regular intervals with the correct size and certified HERO CO2 cartridge.

​

Can I use any cartridge?

HERO shirts use certified CO2 cartridges. You should only use a HERO certified cartridge when replacing spent cartridges. HERO certified cartridges have the correct amount of CO2 ensuring your shirt will inflate. Cartridges which are not certified may fail to inflate your shirt to the correct level.

 

Where do I buy replacement cartridges?

HERO rearming kits (CO2 cartridges and safety clips) are available through our online shop.

SOS3.JPG

 

 

What size cartridge do I need?

It is vital to use the correct size CO2 replacement cartridge. Your HERO shirt was supplied with the correct volume cartridge. The cartridge size required for your shirt is printed on the inflation bladder.

​

Can I use more than one cartridge to inflate my hero?

You should never use more than one correct size cartridge to inflate your HERO. If your HERO failed to inflate fully you can use the oral inflation tube to add more air. Never add more CO2 by activating another CO2 cartridge, this could severely damage your shirt. 

​

What is the auto-activation sensing bobbin?

For the Bondi model, the water bobbin will be green in color if unused. If the auto sensing bobbin has been activated the bottom of the cartridge will show a red disc. The bobbin can only be used once.  If activated, it will need to be replaced with the correct UML part, available through the SOS online shop.  The autosensing bobbin is located on the bottom of the UML inflator. The autosensing bobbin should only be used if you are not intending on entering the water (fishing from a jetty or rocks, etc). When fitted to the shirt, it will self-activate and inflate the shirt if you fall into the water.

​

The bottom of the bobbin will be green in color if unused. If the auto sensing bobbin has been activated, the bottom of the cartridge will show a red disc. The bobbin can only be used once. If activated, it will need to be replaced with the correct UML part which is available through the SOS online shop.

​

Can I replace the shirt and inflation chamber?

If your HERO Rash Guard Shirt or inflation chamber has been damaged or the shirt has worn out you can buy a replacement through our online shop. When ordering a replacement it is important the correct size inflation chamber is used.  

bottom of page